ꢀ
English
Copyright © ViewSonic Corporation, 2004. All rights reserved.
Macintosh and Power Macintosh are registered trademarks of Apple Computer, Inc.
Microsoft, Windows, Windows NT, and the Windows logo are registered trademarks of
Microsoft Corporation in the United States and other countries.
ViewSonic, the three birds logo, OnView, ViewMatch, and ViewMeter are registered
trademarks of ViewSonic Corporation.
Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors or
omissions contained herein; nor for incidental or consequential damages resulting from
furnishing this material, or the performance or use of this product.
In the interest of continuing product improvement, ViewSonic Corporation reserves the
right to change product specifications without notice. Information in this document may
change without notice.
No part of this document may be copied, reproduced, or transmitted by any means, for any
purpose without prior written permission from ViewSonic Corporation.
Product Registration
To meet your future needs, and to receive any additional product information as it becomes
For Your Records
Product Name:
Model Number:
Document Number:
Serial Number:
Purchase Date:
ViewSonic SP2002
VSACC27951-1
VSCEPRSPEC6623
______________
______________
07/08/03 A
ViewSonic
SP2002
1
English
Specifications
Driver
Tweeter: 1” (2.54cm)
Micro Driver Full Range: 2” (5.08cm)
P. M . P. O.
6 0 0 Wa t t .
RMS
20Watt
Frequency Range
Amplifier
35 Hz ~ 20 KHz
Internal
Function
Power / Volume
Indicator
Power
Power Supplier
Adaptor
External
AC input Power: 100 ~ 240V
DC output Power: 12V / 1.66A
Stereo jack / RCA
267.7mm (H) x 90mm (W) x 105.3 (D) mm
10.54” (H) x 3.54” (W) x 4.15” (D)
Connection cables X 2
Adaptor X 1
Connector
Dimension
Contents
User Guide X 1
Speaker X 2
Stereo Jack-RCA adaptor x 1 (optional)
THD
<0.4%@-7dB
Regulations
CCC, BSMI, CE, C-tick, VCCI, ICES003, UL,
FCC-B, CB, NOM, GOST, PCBC, PSB
Troubleshooting
No sound from any speakers
• Power is not turned on
- Verify the power adoptor is plugged into the wall outlet.
- Verify the Power On switch has been pressed.
•
Volume setting is too low
- Press the function key to raise the system Master Volume.
- Check volume level on computer sound card or alternate audio source device and set
at mid level.
•
•
Audio cable is not connected to audio source
- Connect audio cable from audio source. Make sure thee signal cables are inserted
firmly into the correct jacks.
Audio cable connected to wrong output on audio source
- Make sure that the lime green 3.5 mm stereo jack is connected to the line-out of the
audio source; make sure it is fully inserted.
Sound is distorted
• Volume level set too high
- Decrease the speaker system's master volume level.
•
Windows volume control is set too high
- Adjust the Windows volume and balance controls to the center as a starting point, then
use the speaker controller to adjust the volume.
•
Sound source us distorted
- WAV files are often of poor quality. So distortion and noise are easily noticed with high-
powered speakers. Try a different sound source like a music CD.
ViewSonic
SP2002
3
English
Limited Warranty
VIEWSONIC SPEAKER SYSTEM
What the warranty covers:
ViewSonic warrants its products to be free from defects in material and workmanship during
the warranty period. If a product proves to be defective in material or workmanship during the
warranty period, ViewSonic will, at its sole option, repair or replace the product with a like
product. Replacement product or parts may include remanufactured or refurbished parts or
components.
How long the warranty is effective:
ViewSonic Speaker, including the Driver, are warranted for one (1) year for all parts and one
(1) year for all labor from the date of the first consumer purchase.
Who the warranty protects:
This warranty is valid only for the first consumer purchaser.
What the warranty does not cover:
1.
2.
Any product on which the serial number has been defaced, modified or removed.
Damage, deterioration or malfunction resulting from:
a. Accident, misuse, neglect, fire, water, lightning, or other acts of nature, unauthorized
product modification, or failure to follow instructions supplied with the product.
b. Repair or attempted repair by anyone not authorized by ViewSonic.
c. Any damage of the product due to shipment.
d. Removal or installation of the product.
e. Causes external to the product, such as electrical power fluctuations or failure.
f. Use of supplies or parts not meeting ViewSonic’s specifications.
g. Normal wear and tear.
h. Any other cause which does not relate to a product defect.
3.
Removal, installation, and set-up service charges.
How to get service:
1.
For information about receiving service under warranty, contact ViewSonic Customer
Support.
You will need to provide your product's serial number.
To obtain service under warranty, you will be required to provide (a) the original dated
2.
sales slip, (b) your name, (c) your address, (d) a description of the problem, and (e)
the serial number of the product.
3.
4.
Take or ship the product freight prepaid in the original container to an authorized
ViewSonic service center or ViewSonic.
For additional information or the name of the nearest ViewSonic service center,
ontact ViewSonic.
4
ViewSonic
SP2002
English
Limitation of implied warranties:
THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, WHICH EXTEND BEYOND THE
DESCRIPTION CONTAINED HEREIN INCLUDING THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Exclusion of damages:
VIEWSONIC'S LIABILITY IS LIMITED TO THE COST OF REPAIR OR REPLACEMENT OF
THE PRODUCT. VIEWSONICSHALL NOT BE LIABLE FOR:
1.
DAMAGE TO OTHER PROPERTY CAUSED BY ANY DEFECTS IN THE PRODUCT,
DAMAGES BASED UPON INCONVENIENCE, LOSS OF USE OF THE PRODUCT,
LOSS OF TIME, LOSS OF PROFITS, LOSS OF BUSINESS OPPORTUNITY, LOSS
OF GOODWILL, INTERFERENCE WITH BUSINESS RELATIONSHIPS, OR OTHER
COMMERCIAL LOSS, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES.
2.
3.
ANY OTHER DAMAGES, WHETHER INCIDENTAL, CONSEQUENTIAL OR
OTHERWISE.
ANY CLAIM AGAINST THE CUSTOMER BY ANY OTHER PARTY.
Effect of state law:
This warranty gives you specific legal rights, and you may also have other rights which vary
from state to state. Some states do not allow limitations on implied warranties and/or do not
allow theexclusion of incidental or consequential damages, so the above limitations and
exclusions may not apply to you.
Sales outside the U.S.A. and Canada:
For warranty information and service on ViewSonic products sold outside of the U.S.A. and
Canada, contact ViewSonic or your local ViewSonic dealer.
ViewSonic Speaker System (V1.0)
ReleaseDate: 07-08-2003
ViewSonic
SP2002
5
English
Customer Support
Country or Region
www / E-mail address
Telephone / Fax
United States
(800) 688-6688
(909) 468-1202
Canada
(800) 688-6688
(909) 468-1202
United Kingdom
Ireland
0800 833 648
(01293) 643910
Contact your reseller
Europe, Middle East, Baltic
countries and North Africa
Contact your reseller
Australia and New Zealand
+ 61 2 9906 6277
+ 61 2 9906 6377
Singapore/Southeast Asia, India
+ 65 6273 4018
+ 65 6273 1566
Other Asia/Pacific
countries and Indian Peninsula
service@sd.viewsonic.com
+ 886 (2) 2246-3456
+ 886 (2) 8242-3668
South Africa
service@sd.viewsonic.com
+ 886 (2) 2246-3456
+ 886 (2) 8242-3668
Appendix
Compliance Information for U.S.A.
This equipment has been tested and found to comply with the limits for a Class B digital
device,pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to redio
communications. However, there is no guarantee that interference will not occur in a
perticular installation. If this equipment does cause harmful interference radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
To assure continued FCC compliance, the user must use grounded power supply cord
and the provided shielded video interface cable with bonded ferrite cores. If a BNC
cable is going to be used, use only a shielded BNC(5) cable. Also, any unauthorized
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this device.
6
ViewSonic
SP2002
|